Sky Logistics Node

Sky Logistics Node is a block added by Sky Logistics.

Obtaining

Drops from

Table	Source	Rate	Count	Conditions
Sky Logistics Node	blocks	always	1	survives_explosion

Guidebook

Nodes and Pipe Endpoints

A Sky Logistics Node is the wireless equivalent of a pipe endpoint. Normal placement defaults to insert mode; sneak placement defaults to extract mode. The node attaches to the clicked block side and accesses the adjacent block from that direction.

One craft gives 2 nodes. Nodes have no internal buffer; they only pair same-line endpoints for transfer.

In the node screen, each face can be disconnected, extract, or insert. Only connected faces participate in a line. The block model shows the main visual mode, but the actual behavior comes from the per-face settings.

Nodes also have resource toggles, priority, and redstone controls. Higher-priority insert targets are attempted earlier. A face blocked by redstone is paused and is not treated as a failing endpoint.

Logistics Overview

Sky Logistics Nodes provide wireless transport. Set an extract face and an insert face to the same line, and resources can travel directly between them. For a wired network laid out block by block, use the simple pipes introduced in the first chapter.

A line can carry items, fluids, and energy. Nodes are configured per face: extract faces pull from adjacent machines or containers, and insert faces push into adjacent machines or containers. The node screen lets you edit all six directions independently.

Typical setup: create a line with the configurator, place one node beside a source and set it to extract, place another same-line node beside a destination and set it to insert, then copy and paste settings for repeated machines.

节点与管道端点

天穹物流节点是无线管道的端点。普通放置时默认存入，潜行放置时默认抽取。节点会贴在你点击的那一侧，只和紧挨着的机器或容器交互。

一次合成会得到 2 个节点。节点本身不存东西，只负责把同一条线路上的抽取端和存入端连起来。

打开节点界面后，可以分别设置每一面：不连接、抽取或存入。只有设置好的面会工作，所以一个节点也可以同时服务不同方向。

节点还能选择搬运物品、流体或能量，设置目标优先级，并用红石控制开关。优先级高的存入端会优先接收；红石条件不满足时，该面会暂时停工。

物流总览

天穹物流节点提供无线运输：你只需要把抽取节点和存入节点设为同一条线路，物品、流体或能量就会从源头直接送到目标。若需要沿方块铺设的有线网络，请使用手册第一章介绍的简易管道。

一条线路可以同时搬运物品、流体和能量。每个节点的六个方向都能单独设置：抽取负责从旁边的机器或容器拿出资源，存入负责把资源送进去。

推荐流程：先用配置器建立一条线路；在源机器旁放节点并设为抽取；在目标容器旁放同线路节点并设为存入。以后要扩展时，用配置器复制和粘贴设置。